Uline SANITAIRE H-2665 Guía De Solución De Problemas

H-2665
SANITAIRE
®
BAGLESS VACUUM
OPERATING ISSUE
Motor will not start.
Motor suddenly stops.
Does not clean the carpet or floor.
PAGE 1 OF 6
1-800-295-5510
uline.com
TROUBLESHOOTING
Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
The vacuum has overheated and triggered the thermal cutoff.
(See instructions page 2)
vacuum and check for possible sources of overheating, such as a full dust
cup, blocked hose or clogged filter. Wait for at least 30 minutes before
attempting to use vacuum again to ensure the motor has completely
cooled down.
Clean or replace the filters: Hint: If picking up fine dust, the filters may not
look dirty, but a fine substance tends to reduce suction when it blocks the
airflow through the filters.
Be sure the dust cup is properly seated into the vacuum body.
(See instructions page 4)
Empty dust cup. (See instructions page 4)
Be sure upper hose adapter is secure on back of vacuum.
(See instructions page 8)
Check upper hose and lower hose.
Replace a broken, cut, loose or out of shape belt.
for how to tell if belt needs to be replaced.
Clean hair and thread from bristles and end cap area.
Replace brush roll if bristles are worn.
Be sure that vacuum is set to correct carpet height setting.
(See instructions page 3)
Pour le français, consulter les pages 5-6.
RECOMMENDATIONS
Push the On/Off switch to OFF (0), unplug the
(See instructions page 7)
Para Español, vea páginas 3-4.
(See instructions page 6)
0321 TH-2665