Publicidad
Idiomas disponibles
Idiomas disponibles
2 lights lit
1 light lit
1 light flashing
●Continuous Use
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15minutes before proceeding with a fresh battery.
●Over Discharge Protection
This machine is equipped with an over discharge
protection circuit. When the battery is low, the
protection circuit will be opened and the machine will
stop rotating.
●Disposing of Battery pack
Lithium ion battery is contained in the battery
cartridge. For environmental protection, recycle or
dispose of the worn out battery properly. Please
consult with your local relevant departments about
how to recycle and/or dispose of the worn out battery.
To recycle or dispose of the worn out battery:
a)Remove the battery from the tool when it is worn
out.
b)Wrap the terminals with a strong tape to avoid
short-circuit and electric leakage.
Never attempt to disassemble or disembowel the
battery!
●Installing or Removing Tool
The tool here includes driver bit, drill bit, etc., which
differs from the concept of power tools or machines.
CAUTION: Before operation, always set the
reversing switch lever in the central position and
remove the battery. And press the switch button
is absolutely prohibited.
1. Installing instrument
Insert the tool, turn the lock ring of the drill chuck
clockwise (from the front of the tool to the
back), and tighten the tool.
1
2
3
4
2. Removing Tools
To remove the bit, hold the ring and turn the sleeve
counterclockwise (view backwards).
25%-50%
10%-25%
Low level
1.Front
2.Behind
3.Tool
4.Lock Ring
1
2
3
4
●Switch Action
To start the tool, simply pull switch trigger. Tool
speed is increased by increasing pressure on the
switch trigger and further pressure results in an
increase in speed. Release the switch trigger to
switch off the tool.
CAUTION:
1.Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
2.Do not operate the machine at a low speed
for too long, or the inside machine may be
overheated.
1
●Reversing Switch Action
CAUTION:
●Always check the direction of rotation before
operation.
●Use the reversing switch lever only after the tool
comes to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the reversing
switch lever to the neutral position
●Never force to pull the switch trigger while the the
reversing switch lever is set to the center position.
●Clockwise Rotation
Depress the reversing switch lever from side B to
side A for clockwise rotation for drilling and driving in
screws (viewforwards).
Depress the reversing switch lever from side A to
side B for counterclockwise rotation for loosening or
unscrewing screws.
1.Front
2.Behind
3.Tool
4.Lock Ring
1.Switch Button
EN
11
Publicidad
