Publicidad
Idiomas disponibles
Idiomas disponibles
prevent the bit from slipping, a pointed punch and
hammer can be used to make a mark on the metal
plate where the hole is intended to be drilled, and
then the bit tip can be pointed to the mark on which
the hole is drilled. When drilling on bricks, walls and
stones, aim the mark
the drill against the operating object, and press the
switch to drill.
●Tightening Bolt
CAUTION:
1. Set the tap position at the low speed.
2. Make sure that the driver bit is inserted vertically in
the bolt head, or the bolt or the bit may be damaged.
3. Please choose suitable torque according to your
operational need.
To tighten bolt, hammer the point of the driver bit at
the bolt head and force the tool properly. Switch on
the tool slowly and then speed it up gradually. Once
the clutch is closed, release the switch trigger.
When tightening wood screws, drill a center hole first
to make tightening action much easier and to prevent
workpiece from sliding. Please refer to the following
sheet:
When tightening wood screws, drill a center hole first
to make tightening action much easier and to prevent
workpiece from sliding. Please refer to the following
sheet:
Nominal Diameter
of Wood Screw(mm)
3.1
3.5
3.8
4.5
4.8
5.1
5.5
5.8
6.1
●Removing Bolt
To remove the bolt, hammer the point of the driver bit
at the bolt head and force the tool properly. Switch on
the tool slowly and then speed it up gradually. Once
the bolt is taken out, release the switch trigger.
and indicator arrows, press
Recommended Size of
Center Hole(mm)
2.0-2.2
2.2-2.5
2.5-2.8
2.9-3.2
3.1-3.4
3.3-3.6
3.7-3.9
4.0-4.2
4.2-4.4
2
1
CAUTION:
Please put the gear in "1" (low speed): Make sure
the head is inserted vertically into the screw head,
otherwise the screw or the head may be damaged.
Please select the appropriate torque according to
your word needs.
MAINTENANCE AND
INSPECTION
●Inspecting
When the machine is issued or retracted, the
custodian must conduct a daily inspection; before
use, the user must conduct a daily inspection; the
unit using the machine must have a full-time staff
to conduct regular inspections; inspect at least
once a year; In areas with damp heat and frequent
temperature changes or places with harsh operating
conditions, the inspection period should be shortened
accordingly; inspections should be carried out in time
before the rainy season.
For machines that have passed regular inspections,
the inspection "qualified" mark should be pasted on
the appropriate parts of the machine. The "qualified"
mark should be clear, clear and correct and include
at least: machine number, inspection unit name or
mark, inspector name or mark, and effective date.
●Cleaning Ventilation Slots
Always adjust the reversing switch to the center
position when servicing the power tool to replace the
tool on the power tool or to move the power tool.
The maintenance of the machine must be carried
out by a maintenance organization approved by the
original manufacturer. The user and maintenance
department shall not arbitrarily modify the original
design parameters of the machine, and shall not
use substitute materials that are lower than the
performance of the raw materials and parts and
components that do not conform to the original
specifications.
●Deposit
When do not need to use the machine for a long
time, please pull out the battery pack. The battery
packages exist away from the metal objects, such
as paper clips, COINS, keys, nails, screws, or other
1.Drive Bit
2.Bolt
EN
13
Publicidad
