Publicidad
Idiomas disponibles
Idiomas disponibles
Connection
The Connection tab is divided into two main sections, Contour Name Assignment and Wireless
Setup.
Contour name assignment
See page 10 for more information on how to assign a unique name for Contour.
Automatic wireless setup
See page 10 for information on automatic wireless setup.
Manual wireless setup
If your wireless network is not broadcasting an SSID, you will need to configure your wireless
settings manually.
1. Select 'Configure Manually' from the Network drop-down list and select the encryption
type of your wireless network from the drop-down list below. Contour supports the following
encryption types:
•
No Encryption
•
WEP
•
WPA
•
WPA2
Note: Please check your wireless router configuration to find out the type of encryption that
is being used on your wireless network.
2. Enter the passphrase/key needed to connect to your network in the box below, if one is
required.
3. Click Connect. The Status LED will then flash red to indicate that Contour is rebooting. When
Contour has started up it will enter Sleep mode.
Select this option if your wireless network is unsecured.
Select this option if your wireless network is being secured using the
Wired Equivalent Privacy (WEP) method.
Select this option if your wireless network is being secured using the
Wi-Fi Protected Access (WPA) method.
Select this option if your wireless network is being secured using the
Wi-Fi Protected Access II (WPA2) method.
Contour Name
Assignment
Wireless Setup
EN
17
Publicidad
