Hansgrohe ShowerSelect 15738 0 Serie Modo De Empleo/Instrucciones De Montaje página 6

�
Safety Notes
� Gloves should be worn during installation to prevent
crushing and cutting injuries.
� The product may only be used for bathing, hygienic
and body cleaning purposes.
� Children as well as adults with physical, mental and/
or sensoric impairments must not use this product
without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from
using this product.
� The hot and cold supplies must be of equal
pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• If the thermostat or mixer is set to maximum water
temperature, there is a risk of scalding at hydraulical
opening of the check valve. For this reason,
Hansgrohe recommends that you set up the "Safety
Function".
Special information for UK
If installing this product with a pump, please be aware
that it has to have negative head switching. This product
will not function with a positive head pump.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
• Safety against backflow
• The product is exclusively designed for drinking
water!
6
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
English
Symbol description
Do not use silicone containing acetic acid!
Safety Function (see page 68)
The desired maximum temperature for example max.
42º C can be pre-set thanks to the safety function.
Adjustment (see page 68)
After the installation, the output temperature of the
thermostat must be checked. A correction is necessary if
the temperature measured at the output differs from the
temperature set on the thermostat.
Maintenance (see page 72)
• The check valves must be checked regularly
according to EN 806-5 in accordance with national
or regional regulations (at least once a year).
• To guarantee the smooth running of the thermostat, it
is necessary from time to time to turn the thermostat
from total hot to total cold.
Dimensions (see page 70)
Flow diagram (see page 70)
free flow

Outlet 1

Outlet 2
Spare parts (see page 74)
XXX = Colors
000 = Chrome Plated
140 = Brushed Bronze
250 = Brushed Gold-Optic
340 = Brushed Black Chrome
400 = White/Chrome Plated
600 = Black/Chrome Plated
670 = Matt Black
700 = Matt White
990 = Polished Gold-Optic
+ Special accessories (see page 75)
order as an extra
• extension 25 mm #13595000
• Extension Set 22 mm (when wall is not deep
enough) #13597XXX, #13593XXX,
#13604000
• levelling set 1° #95521000
Cleaning (see page 76)