Controls - Colged TopTech 31-22.1 Manual De Instrucciones

UK

Make sure that the level of water in the washing tank, once filled, is 1-2 cm below the overflow
level.

Make sure that the temperature of the washing and rinsing tank is in accordance with the settings.

Check the dispensers for proper function.

Make sure the rinsing economiser is working well: it must start dispensing hot water as soon as a
basket arrives beneath the rinsing jets, and make the hot water flow stop when the basket moves
away.

Make sure the limit switch is working. The switch must block the functioning of the advancement
motor and of the pump whenever a basket reaches the end of the plane. Once the basket is
removed, the functioning must resume.

Check the rotation direction of the pumps. If they are turning in the opposite direction, invert the
two phases of the power supply cable.
Failure to carry out these checks will automatically annul the warranty.
END OF INSTALLATION

The installation technician must inform the manufacturer in case of functioning and/or safety
anomalies observed during the initial testing.

The machine can only be used once installation is complete.

The technician must issue a declaration of work carried out according to the rules of the trade and to
the laws in force.
Page 16 of 33
DISHWASHER INSTRUCTIONS MANUAL

Check the regulation of the mechanical safety system of the conveyor,
which must be adjusted taking into account the overall length of the
machine and of the output tables measured by themselves.
A full load of baskets full of plates should not block the advancement of
the conveyor.
To make the regulation, turn the screw on the bracket that supports the
conveying motion unit.
The advised L length must range from 60 to 75 mm (see figure).
Please contact your assistance centre for complex applications.

Make sure that the rotation direction corresponds to the figure and to
the central motion of the conveyor.
WARNING: The mechanical safety will not work efficiently if the
rotation direction is incorrect.

Controls

MDITT31-(r06)