Bimar ZHQ1545 Folleto De Instrucciones página 8

Fax +32 030 9904733

WARNING
D
o not use this heater in small rooms when they are occupied by person not capable of
leaving the room on their own, unless constant supervision is provided.
U
nplug the appliance when not in use.
T
o avoid all risk of electric shock, never immerse the power cable, plug or appliance itself in
water.
A
fter being switched on or off the appliance may make a clicking sound due to the heating or
cooling of its metal parts; this is not a sign of malfunctioning.
D
o not touch the heater with wet hands or feet.
T
he appliance has a IP55 rating and is therefore insulated against limited dust and limited
water jets from all directions. For the purpose of safety, bear these indications in mind.
D
o not expose the heater to the weather (sun, rain, etc.)
I
f the appliances falls or works badly, disconnect the electrical cable immediately. Check
that no part is damaged and switch it on after these controls: in case of doubt, contact
professionally qualified persons.
D
o not pull on the power cord or the appliance to unplug the appliance from the electric
socket.
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
INSTALLATION
After removing the packaging, check that the appliance is not damaged. If in doubt, do not use but
contact a professionally qualified expert. The parts of packaging (plastic bags, polystyrene, nails,
etc.) must not be left within children's reach since they are potential sources of danger; dispose of
them in compliance with current regulations.
Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded. If the plug on the appliance does not fit the
socket, have the socket changed with a suitable type, by a professionally qualified expert who will
make sure that the socket cable section is suitable for the power absorbed by the appliance.
Generally we advise against the use of adaptors and/or extensions but if their use is indispensable,
they must comply with current safety norms and their electric capacity (ampères) must not be less
than the maximum stated for the appliance.
For outdoor use: the socket must only be weatherproof and suitable for outdoor use.
The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
The appliance must not be positioned immediately under a socket.
The appliance must only be installed horizontally (i.e. the longitudinal axis must be horizontal) and
with the switch facing down.
Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
Do not cover or block the aeration slots and the front grid of the appliance in order to prevent
overheating.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
: this heater is not equipped with a device to control the room temperature.
Assembly page 8/28
8 28
/