EINHELL RASARRO 36/42 Manual De Instrucciones página 15

Using the mulching adapter (Fig. 11)
In mulching mode, the cuttings are shredded in
the enclosed mower housing and then spread
back onto the lawn. It is not necessary to gather
and dispose of the grass.
Important! Mulching is only possible if the lawn
is relatively short. Mow the lawn regularly in order
to obtain a thin layer of mulch.
Warning!
Insert the mulching adapter only when the motor
is switched off and the safety plug has been
pulled out.
To use the mulching function, disconnect the
collection bag, slide the mulching adapter (Fig.
11/Item 14) through the ejector opening and close
the ejector fl ap again.
Adjusting the cutting height
Caution!
Adjust the cutting height only when the machine
has been switched off and the safety plug has
been pulled out.
The cutting height is adjusted as follows (see Fig.
12):
1. Push the lever (8) outwards.
2. Set the lever (8) to the desired cutting height.
3. Release the lever (8) and check that it is
securely seated in the lock.
Reading off the cutting height
The cutting height can be set between 1" - 3" in 6
intervals, and can be read off on the scale.
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners
are damaged. To prevent any imbalance, replace
blunt and/or damaged blade. To carry out this
check, fi rst switch off the motor and pull out the
safety plug.
5.1 Charging the Lithium-Ion battery
The corresponding instructions can be found
in the original operating instructions for your
charger.
5.2 Battery capacity indicator
(Fig. 13)
Press the battery capacity indicator switch (23).
The battery capacity indicator (22) shows the
charge status of the battery using 3 LEDs.
Anl_Rasarro_36_42_SPK7_USA.indb 15 Anl_Rasarro_36_42_SPK7_USA.indb 15
EN
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Installing the battery (Fig. 14)
Open the battery cover. Then insert the batteries
in the mounts as shown in Fig. 14.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The equipment's operating time depends on
the battery with the lower charge level. The two
batteries must always be fully charged before
use. Close the battery cover by fl ipping the cover
down.
6. Operation
Caution!
The lawn mower is equipped with a safety circuit
to prevent unauthorized use. Directly before
starting up the lawn mower insert the safety plug
(Fig. 15/Item 17) and remove the safety plug
again whenever you interrupt or terminate your
work.
Important!
To prevent the equipment switching on
accidentally, the lawn mower is equipped with
a safety switch (Fig. 1/Item 2) which must be
pressed before the switching bar (Fig. 1/Item 3)
can be activated. The lawn mower switches itself
off when the switching bar is released. The start
time can amount to several seconds. Repeat
this process several times so that you are sure
that the machine functions properly. Before you
perform any repair or maintenance work on the
equipment, ensure that the blade is not rotating
- 15 -
15.12.2022 08:52:24 15.12.2022 08:52:24