EINHELL RASARRO 36/42 Manual De Instrucciones página 19

10. Troubleshooting
Problem
Motor does not start
or comes to a stop
(loose connection).
The motor
performance drops.
Cutting is irregular.
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period.
Anl_Rasarro_36_42_SPK7_USA.indb 19 Anl_Rasarro_36_42_SPK7_USA.indb 19
EN
Possible causes
a) Motor terminals disconnected.
b) The mower is standing in high
grass.
c) The mower housing is clogged.
d) Safety plug is not inserted.
e) Battery is not correctly inserted.
f) Insuffi cient or no contact between.
the handle and the handle fastener
(Fig. 3 / Section 5).
a) The grass is too high or too damp.
b) The mower housing is clogged.
c) The blade is severely worn.
d) Battery performance
decreasing.
a) The blade is worn.
b) Wrong cutting height.
- 19 -
Solution
a) Have repaired by service center.
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary.
c) Clean the housing so that the blade
moves freely.
d) Insert safety plug (see 6).
e) Remove the battery and reinsert
(see 5).
f) Undo the handle connection, check
the contacts for dirt and carefully
clean with a brush. Tighten the
handle connection (see 5).
a) Correct the cutting height.
b) Clean the housing.
c) Replace the blade.
d) Check the battery performance-
and charge the battery if necessary
(see 5).
a) Replace or re-sharpen the blade.
b) Correct the cutting height.
15.12.2022 08:52:24 15.12.2022 08:52:24