Hama Nano Instrucciones De Uso página 8

11. Troubleshooting
Q. My universal remote control does not work!
A. Check the AV device. If the main switch on the device is off, the universal remote
control cannot operate the device.
A. Check that the batteries are inserted correctly and that the polarity has been
observed.
A. Check that you have pressed the appropriate device button for the device.
A. Replace the batteries if the battery level is low.
Q. If there are multiple device codes listed for the brand of my AV device, how do I select
the correct device code?
A. To determine the correct device code for the AV device, test the codes one after the
other until most of the buttons work properly.
Q. My AV device only responds to some button commands.
A. Try other codes until most of the buttons work properly.
Q. The brand of my AV device is not mentioned in the code list.
A. In this case, use the code search for all brands (Section 5.1)
Q. I have tried all the available codes for the brand of my AV device from the code list,
but none of the codes mentioned work.
A. In this case, use the code search for all brands (Section 5.1)
12. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.
6