mysoda GLASSY Manual De Instrucciones página 7

TROUBLESHOOTING
ISSUE:
Water bottle can't be attached to the
quick lock
Water bottle can't be released from the
quick lock
Water bottle overflows during the
carbonation
Water is not well carbonated/bubbly
enough
CO2 cylinder leaks after installation
Small, white ice particles form around
the nozzle during the carbonation
Device makes a whistling noise during
the carbonation
A small amount of water is formed
under the device after carbonation
PROBABLE CAUSE:
Quick lock is in wrong position
Water bottle is in wrong position
Bottle is overfilled.
Carbonating button is pressed too long
CO2 cylinder is running low
Water is too warm
CO2 cylinder is not screwed in tight
enough
CO2 cylinder is not screwed in tight
This is normal, especially when the
water is cold
This is normal and ends once the
carbonation is completed
A small amount is normal, as the
water from inside the device should
leak outside from the small holes
underneath the device.
SOLUTION:
Pull the quick lock and nozzle towards
yourself. Attach the bottle by turning
one quarter anti-clockwise.
Gently pull the water bottle towards
yourself until it reaches its fully forward
tilt position. Release the bottle by
turning one quarter clockwise.
Fill the bottle with water up to the fill
line indicating the maximum level.
Do not press the carbonating button for
longer than 1–2 seconds at a time.
Replace the used CO2 cylinder with a
new one.
Make sure the water used is as cold
as possible as CO2 dissolves better in
cold water.
Screw the CO2 cylinder tightly into
the device.
Remove the CO2 cylinder and reattach
it securely. Do it by hand, do not use
tools. Do not overtight.
Pull the bottle towards you to release
the pressure
inside the bottle, which also melts the
ice particles into the water.
If the device leaks more water it might
be that water bottle is overfilled or
carbonating button pressed too long.
Check issue "Water bottle overflows
during the carbonation".
ENGLISH
7