Descargar Imprimir esta página

Topcom Twin Talker 3800 Manual De Usuario página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
TOPCOM TWINTALKER 3800
9
LCD DISPLAY INFORMATION
i
h
SCAN
g
VOX
f
DCM
e
d
c
10
BATTERY CHARGE LEVEL/LOW BATTERY INDICATION
The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the BATTERY icon on the LCD
Screen.
SCAN
VOX
DCM
When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be
replaced or recharged.
11
RECHARGING BATTERIES
The PMR can be used with 3 alcaline or rechargeable NiMh AA batteries (included).
Only use the AC/DC ADAPTER with "AA" rechargeable batteries. Do not charge this unit
when regular "AA" alkaline batteries are installed.
When using rechargeable batteries you can use an optional adapter to charge.
15
12
USING THE TWINTALKER 3800
12.1 TURNING THE UNIT ON/OFF
To activate; press and hold
To switch off; press and hold
6
j
a.
RX icon - Displayed when receiving a signal
b.
TX icon - Displayed when transmitting a signal
c.
Speaker volume indicator
d.
Battery charge level indicator
a
e.
Lock icon - Displayed when the keypad is locked.
b
f.
Dual Scan icon - Displayed when dual scan mode is active
g.
VOX icon - DIsplayed in Voice controlled (Vox) mode
h.
Scan icon - Displayed when scan mode is active
i.
Channel number
j.
CTCSS code
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
Dispose of batteries at a designated battery disposal unit and
not in the household waste. Do not short-circuit & dispose of in
fire. Remove the batteries if this device is not going to be used
for a long period.
• Insert 3 "AA" rechargeable batteries.
• Plug the small plug of the adapter into the SPK/MIC/CHG jack (15) and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries
properly. There is no charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the
batteries.
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
TOPCOM TWINTALKER 3800

Publicidad

loading