Preparing For Use; Assembling The Breast Pump - Philips SCF330/60 Manual De Instrucciones

Caution
- The breast pump is only intended for repeated use by a single user.
- Never drop or insert any foreign object into any opening.
- Never use any accessories or parts from other manufacturers or that Philips AVENT does
not specifically recommend. If you use such accessories or parts, your guarantee becomes
invalid.
- Wash, rinse and sterilise all pump parts before each use.
- Do not use antibacterial or abrasive cleaning agents when you clean breast pump parts.
- Do not continue pumping for more than five minutes at a time if you do not succeed in
expressing any milk.
- If the pressure generated is uncomfortable or causes pain, break the seal between the breast
and the pump body with your finger and remove the pump from your breast.

preparing for use

Clean and sterilise all parts of the breast pump before first use as described in chapter 'Cleaning
and sterilising'. Clean all parts after each subsequent use and sterilise all parts before each
subsequent use.

assembling the breast pump

Note: Make sure you have cleaned and sterilised all parts of the breast pump. Wash your hands
thoroughly before you handle the cleaned parts.
Be careful, the cleaned parts may still be hot.
Tip: You may find it easier to assemble the breast pump while it is wet.
1 Insert the white valve into the pump body from underneath. Push in the valve as far as
possible (Fig. 2).
2 Screw the pump body clockwise onto the bottle or storage cup until it is securely
fixed (Fig. 3).
Note: If you use a storage cup, you have to screw the adapter onto the storage cup first.
3 Place the silicone diaphragm with stem into the pump body from above. Make sure it fits
securely around the rim by pressing down with your fingers to ensure a perfect
seal (Fig. 4).
4 Attach the handle onto the diaphragm with stem by hooking the hole in the handle over
the end of the stem. Push down the handle onto the pump body until it clicks into
place (Fig. 5).
5 Place the massage cushion into the funnel-shaped section of the pump body. Push in the
inner part of the massage cushion as far as possible and make sure that it is perfectly
sealed all around the rim of the pump body. Press in between the petals to remove any
trapped air (Fig. 6).
Note: Place the cover over the massage cushion to keep the breast pump clean while you prepare
for expressing.
EngliSh
7