Publicidad
Idiomas disponibles
Idiomas disponibles
Operator's guide:
1. Unpacking instructions
2. Adjusting the shelves
3. Internal cleaning
I
4. External cleaning
5. Connection to the mains
UK
6. Controls
7. Checking correct operation
D
8. Internal cleaning
9. Replacement of internal light bulbs
10. Replacement of the door's magnetic gasket
E
F
!
WARNINGS (see fig. 10)
It is most important that this instruction booklet is kept together with the appliance both for future
NL
reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
P
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
S
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
DK
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
6
7. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
FIN
prior notice. 8
sources of heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems,
B
air conditioning, etc ...).
that the products displayed on the shelves and grills do not hang over the edges.
GR
products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until
CZ
defrosting is completed;if this is not carried out the compressor will continue to operate leading to a
wasteful consumption of electricity and poor performance.
EE
it is indispensable to keep the door open at least 10 cm.
LV
!
Our products are for internal use only do not install outside restaurants, shops
LT
H
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards.
M
WOODEN CRATES 1b.
between the appliance and pallet or crate. . Lift the appliance. . Remove the pallet or crate. . Place
PL
the appliance on a flat, level surface. . Make sure there is nothing left in the package before disposing of
7.
it.
Sort out the packaging materials in order to facilitate disposal (see fig. 1).
SK
2. ADJUSTING THE SHELVES
1.
Raise the shelf.
SLO
making sure there is a shelf on the left and on the right (see figure 2).
3. INTERNAL CLEANING
1.
Clean the internal surfaces and glass panels with a soft sponge and a neutral detergent.
soft dry cloth.
4. EXTERNAL CLEANING
1.
Use the same products as used for the internal cleaning. . Remove the protection from the steel parts
of the panel and grills.
5. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. . Ensure that the supply socket:
rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA.
3
. Ensure that there is no danger of explosion (AD) in the room.
for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
N.B.: If the equipment has been transported or stored overturned, let is rest in its correct position for at
least 3 hours before hooking it up to the mains. . Insert the plug in the socket (do not use three-way
adapters and reduction adapters) (see fig. 3).
5
. Avoid installing the cabinet directly in line with sunlight. . Never install the appliance near
10
. Keep the ventilation grills free from obstruction for at least 30 cm.
Remove the nails from the wooden crate with care.
6
2.
Turn it downwards. . Remove it. . Put it in the new position, in reverse order,
2
Operator's guide
Maintenance manual (Page 48):
1. Cleaning the condenser
2. Cleaning the evaporator
Wiring diagram diagram of refrigeration unit
13
. If the appliance is not working and unused,
3
4
3
4
2
a)
is properly earthed;
complies with the IEC regulations:- thermal-magnetic
c)
4.
5
6
3
9
12
. If damp air or
2.
Insert forks of forklift truck
2.
b)
fulfils the requirements of the
Make sure the environment is suitable
2
11
. Ensure
5
Wipe with a
(A)
attached
Publicidad
