Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 below to continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function
unless battery is installed.
WARNING: Battery is to be inserted with the
correct polarity.
Since this fan comes with an LED light kit, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (ON).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws
from original wall switch. Attach wall plate
(included) to wall control using 2 screws
provided with the wall control.
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning
protrusions on canopy cover with notches in the
hole in the bottom of center of the canopy. Press
up gently but firmly on the canopy and then turn
canopy cover to the right (clockwise) about 1/2 in.
outlet box
green/
green/
green/
bare
bare
bare
ground
ground
ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
canopy
screw
page 7
wall control
green
DIM ON
hanging
bracket
screw
canopy cover
dimmer
switch
face-
plate
wall plate
Publicidad
