Terms Used; Mounting The Torque Tester - Gedore Dremotest E 8612-012 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
3.1

Terms Used

Taring:
First Peak:
Calibration:
Torque
Wrench:
3.2

Mounting the Torque Tester

NEVER use the torque tester if it is not fastened on a solid
surface using adequate fasteners (see below).
ALWAYS make sure using the torque tester will not cause the
mounting surface to tip over.
NEVER use the torque tester in the open or in damp spaces.
For fastening on a suitable surface, Gedore recommends
hexagon or cylinder head screws (4 piece) size M8 with
minimum strength class 8.8 (M10 with minimum strength
class 8.8 for 8612-3150), with suitable washers and nuts.
ALWAYS position the unit as not to create any pinch points
between the torque tester, the torque wrench, and the
mounting surface.
EN
Null balancing; the torque is set to "0".
Break point detection (the torque wrench's
release torque is displayed).
Testing measurement accuracy.
Releasing torque wrench according to
DIN EN ISO 6789 Type II.
WARNING
12

Publicidad

Tabla de contenido
loading

Tabla de contenido