Cherubini Plug & Play 3000 Instrucciones página 19

The motor can learn the limit switches in different modes: automatic, manual, mixed.
It is suggested that the strength of the blind, its couplings and its safety lugs be checked.
As long as both of the limit switch positions have not been learned, the motor
will move briefly, stop and then start back up again.
LIMIT SWITCH LEARNING IN AUTOMATIC MODE
To learn the limit switches in automatic mode, the blind must have either
internal or external safety lugs (A).
The motor is capable of automatically detecting the presence of flexible (B) or
rigid (C) ribs for the connection between the tube and the blind.
A
Limit switch learning sequence in automatic mode
1 - Using either the up or down button, open the blind completely until it is fully stopped
and releases the tension.
2 - Continue to hold the button down until the blind begins to move in the opposite
direction (after about 2 seconds), or use the up or down button,until the lower limit
switch is detected.
3 - Release the control button used to perform the procedure and check that the blind
moves without interruption in the direction desired.
Example of automatic limit switch learning:
1
PLEASE NOTE: At the end of the limit switch learning procedure, the motor
automatically assigns the ASCENT to the BROWN wire and the DESCENT to the
BLACK wire.
LIMIT SWITCH LEARNING
B
19
C
2
UP
DOWN
3