Changing Limit Switches; Deleting Of Single Limit Switch Positions; Deleting Of All Limit Switch Positions - Cherubini Plug & Play 3000 Instrucciones

The following command sequences may be performed only after the limit switches have
been learned and only when the motor is completely on one of the two limit switch
positions: either lower or upper limit positions.

DELETING OF SINGLE LIMIT SWITCH POSITIONS

Deleting the UPPER limit starting from the UPPER limit switch position
Deleting the LOWER limit starting from the LOWER limit switch position

DELETING OF ALL LIMIT SWITCH POSITIONS

Deleting both limit switch position starting from the UPPER limit
Deleting both limit switch position starting from the LOWER limit
Deleting of one or both limit switches is indicated by the motor pausing briefly before
moving again until both limit switch positions have been memorised again.
PLEASE NOTE: When the limit switches are deleted, the super-sensitivity settings
are also deleted

CHANGING LIMIT SWITCHES

UP UP DOWN
DOWN DOWN UP
UP UP DOWN
DOWN DOWN UP
22
UP UP UP
HOLD
DOWN DOWN DOWN
HOLD
DOWN
UP UP
HOLD
DOWN DOWN UP
HOLD
2 sec
2 sec
2 sec
2 sec