Publicidad
Idiomas disponibles
Idiomas disponibles
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the blower.
To avoid the risk of fire, the ventilation slots and the exhaust
must remain free of flammable waste.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Only use accessories, oils or greases authorized by VITO.
Not doing so may result in personal injuries or damages to
the blower. In case of doubt, you should contact an official
dealer.
For safety reasons, the fuel conductive components (fuel
hoses, tank, tank cap and couplings) should be checked
regularly for damage and leaks. If necessary, they should
be replaced by an official dealer.
Keep warning and information stickers always clean and
legible.
Keep all nuts and bolts well tightened in order to ensure a
safe operation.
If any components or safety devices are removed for
maintenance
tasks,
immediately.
Let the combustion engine cool down before you put the
machine into an enclosed space. During operation, the
exhaust becomes extremely hot and remains so for a few
minutes after switching off the engine. Avoid touching the
exhaust while it is hot.
Never store the blower with petrol in the tank inside a
building. Petrol vapours may come into contact with flames
or sparks and ignite.
they
must
be
repositioned
Store the blower in a dry area with the fuel tank empty and
the fuel in a well-ventilated compartment. Avoid places
with high humidity to avoid the appearance of corrosion
and rust.
Clean the equipment thoroughly before storage, especially
in winter. Keep the device in a good operating condition.
Make sure the machine is protected against misuse (for
example, by children).
Your blower should only be serviced by the manufacturer's
internal service personnel, or other qualified personnel,
replacing any necessary parts with original parts sourced
directly from the manufacturer.
1. Attach the strap clip (19) to the base of the blower (18);
2. Ensure that the clips are securely fastened.
1. Attach the flexible bellow (13) to the elbow tube and
tighten the bolt of the fastening clamp;
2. Insert the connection tube (9) into the flexible bellow
and tighten the bolt of the fastening clamp;
3. Place the throttle handle clamp (12) on the connection
tube (9). Adjust the position of the handle to allow a
comfortable posture during use and tighten the bolt;
4. Insert the intermediate tube (8) into the connection tube
(9). Turn the intermediate tube counterclockwise until
the holes of the fixing bolt are aligned. Insert and tighten
the bolt;
5. Insert the end tube (7) into the intermediate tube. Turn
the end tube counterclockwise until the holes of the
fixing bolt are aligned. Insert and tighten the fixing bolt.
Publicidad
