Hoshizaki HRE-70A Manual De Instalación página 2

IMPORTANT
1. In order to carry out safe and proper installation
of the product, please read this booklet
carefully beforehand and follow the instructions
contained within.
2. On completion of the installation, start up the
refrigerator/freezer to check for any
abnormalities, and instruct the user on how to
use and maintain the refrigerator/freezer in
accordance with the Instruction Manual.
3. This booklet should be handed over to the user
after the installation and be preserved by the
user together with the Instruction Manual for
any further consultation that may be
necessary.
1. CHECKS BEFORE INSTALLATION
* Visually inspect the exterior of the shipping container,
and any severe damage noted should be reported to
the carrier.
CAUTION
Remove shipping tape and materials holding the
Door, Front Panel, and package containing
accessories. If shipping tape is left in the unit, it
will not work properly.
* Remove the package containing accessories, and
check the contents:
a) Drain Pan Assembly
b) Trayslide
c) Guide (A)
d) Guide (B)
e) Drain Cover
f) Truss Head Machine Screw 5x10
* See the Nameplate on the right interior wall, and
check that your voltage supplied corresponds with
the voltage specified on the Nameplate.
2. LOCATION
IMPORTANT
This refrigerator/freezer is not intended for
outdoor use. Normal operating ambient
temperature should be within 5°C to 43°C.
For best operating results:
* The refrigerator/freezer should not be located next
to ovens, grills or other high heat producing
equipment.
* The location should provide a firm and level foundation
for the equipment.
* Avoid a site where dripping is not allowed.
Especially, a side-by-side or back-to-back installation
(possibly with other manufacturer's unit) may cause
condensation between the two units, resulting in
dripping onto the floor.
* Do not expose the unit to direct sunlight or higher
temperatures.
* Allow at least 100cm clearance at the front of the
unit for smooth door operation. Also allow at least
30cm clearance from the ceiling to the top of the
unit for proper air circulation.
1
8 (70 type)
16 (140 type)
1
* Protect the unit from tipping over by fixing the four
1
Legs with the following tip-resistant kit (optional):
1
4
[Tip-Resistant Kit]
Shakeproof Leg (454440-01, optional)
Shakeproof Fitting (454441-01, optional)
Anchor Bolt M10 (not provided)
[Installation Example]
1) Replace the adjustable ends of the Legs with
the Shakeproof Legs.
2) Fix the two rear Shakeproof Fittings to the floor.
3) Mount the refrigerator/freezer on the fixed
Shakeproof Fittings.
4) Fix the front Shakeproof Fittings.
* Locate and orient the Fittings to optimize the
function of the Anchor Bolts.
* The Shakeproof Legs will raise the height by
about 5mm.
1
ENGLISH
Min. 100cm
Fig. 1
Min. 30cm
4
4
4