Ivoclar digital PrograMill PM3 Instrucciones Breves página 38

Safety
Only approved discs / blocks can be identified and thus used by the device via a
corresponding RFID chip on the disc (RFID label or RFID container on the disc holder) or on
the block holder (RFID container on the block holder), which ensure that misapplication is
nearly impossible.
Basically, all Ivoclar Vivadent materials and tools in their respective categories are suitable
for processing.
All information regarding material and indication extensions corresponds to the state
of knowledge at the time of going to print. For additional details, go to http://www.
ivoclarvivadent.com.
It is not recommended to process materials or use tools from other manufacturers in this
system due to the absence of milling strategy coordination and lack of tool harmonization.
2.1.1 Potential improper use
The device is not suitable for milling procedures outside of the dental field.
The following is considered as misuse of the system:
• Non-compliance with the specified intended use, intended operator specifications or
intended environment
• Modifications, maintenance and repairs without prior authorization from Ivoclar
Vivadent
• Operation with inappropriate parameters
Improper use of the device can lead to the following:
• Danger for patient and operating personnel
• Impairment of the operability of the device
Ivoclar Vivadent assumes no liability for damage resulting from improper use.
Typical misapplications of the device to be avoided:
Improper use
Use of not approved materials or tools
Incorrect cleaning (filter, milling chamber,
changer)
Operation without coolant concentrate
PrograMill Fluid
Shut-down of the device by the user during
the milling operation
Operation without the tank (only applies in
the case of wet operation)
Operation without the suction unit and
filter
38
Consequences
Damage to the device
• Skin irritations
• Environmental damage
• Damage to the device
• Damage to the device
• Service life of device and filter is reduced
• Damage to tools and discs or blocks
• Calibration may be necessary
Device will stop