Enraf Nonius EN-Tree P Instrucciones De Uso página 26

Warnings
Should the use of this device lead to an undesirable event such as death or serious injury to the
user, the manufacturer and the competent authority of the Member State MUST be informed
without delay!
Always use the original Enraf-Nonius accessories that are meant for this product.
The EN-Tree P should be operated or used by one person at once.
Limbs must be kept clear from moving parts.
Clean the cuffs after usage.
During exercising hands must be kept clear from the guiding bars of the weights.
Never re-set weights during exercising.
Do not change the load settings during exercising or training: load changes are only allowed in
the starting position
Avoid the cord grating along sharp paths.
Keep spectators away from the pulley when it is in use (at least 1 meter).
For safety reasons keep sufficient distance from a unit used for training; one should not be
within 1 meter distance from the outer borders of a unit while it's used for training
When using the latissimus grip, first the load must be selected, before the grip is mounted. If
you change the weight in the meantime you have to hold the upperweight to prevent the grip
from falling down.
The 45 degrees Pull Down accessory is only intended for support during exercising. Never apply
the full body weight to the Pull Down accessory. The maximum admissible weight for the 45
degrees Pull Down accessory is 50 kilograms.
When used by children, supervision by a knowledgeable (para)medic is obligatory. At all times
keep children away from the equipment when no supervision is at hand!
A correct bio mechanical positioning of the body is necessary.
When the EN-Tree Pulley is not used in the correct way, injury may occur. Supervision by a
knowledgeable paramedic is therefore obligatory.
If pain is experienced during use: stop the training immediately and consult professional
medical help
In case of damage from transport is noticed, contact your local distributor.
DO NOT USE the device!
Caution
EN-Tree P is powered by low voltage currency, the pneumatic resistance is fed by compressed
air. Use only Enraf-Nonius supplied or prescribed spare parts. A wrong currency or a wrong
pressure can result in damage of the unit.
The manufacturer of the compressor advises frequent maintenance and the use of special oil
lubricants. To prevent malfunction follow the instructions in the service manual of the
compressor.
Take care to prevent the compression of electrical circuits wires and air tubes between the
moving parts and the unit itself.
The device is not intended for use in so-called "wet rooms" (hydrotherapy rooms).
Note
In case of any malfunction of your EN-Tree P contact your Enraf-Nonius supplier or Enraf-Nonius
•
B.V. (Rotterdam, The Netherlands). Have repairs, maintenance and installations carried out by an
authorized Enraf-Nonius service technician
Repairs or maintenance performed by a non Enraf-Nonius authorized service technician and/or
•
the use of (spare) parts that are not originally Enraf-Nnius made, results in a direct loss of any
guarantee
The maximum resistance setting for the training equipment will be dependent on the pressure of
•
the compressor
Page 8 of 16 EN109-1400755-48 IFU