1
2 1/2
5
CAUTION:
the ratio of the mixture drastically when you
mix small quantities of fuel. Measure the
quantity of oil carefully and make sure that
you get the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
8
2 ½
6 ½
12 ⅞
Small errors can influence
Do not mix fuel for more
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to
To install the leaf catcher and the blade
tip protection
1. Remove the outer 8 nuts from the bolts on the blade.
2. Put the leaf catcher on the 8 bolts. Refer to
overview on page 2 , to see where the leaf catcher is
on the product.
3. Put the blade tip protection on the 2 bolts on the tip
of the blade.
4. Install the 8 nuts to the bolts.
5. Torque the nuts to 7 Nm.
To start the product with a cold engine
1. Pull the choke control to choke position.
2. Push the air purge bulb approximately 6 times or
until the bulb starts to fill with fuel. It is not necessary
to fill the air purge bulb fully.
3. Hold the body of the product on the ground with your
left hand. Do not step on the product.
4. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force.
WARNING:
rope around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle.
5. Continue to pull the starter rope handle until the
engine fires, then push the choke control to its initial
position.
WARNING:
the engine starts.
Product
Do not wind the starter
Do not pull the starter
The blades move when
906 - 005 - 30.01.2021