Publicidad
Idiomas disponibles
Idiomas disponibles
ABYSS IP66 Installation Instructions
3. Install the fan host ring cover back to the motor assembly. Lock it by turning clockwise. (Fig.9)
NOTE: Don't run the motor without blades installed!
HANGING OF THE FAN (Fig.10)
Lift the fan assembly onto the mounting bracket. Ensure the key slot (A) of the hanger ball is positioned on
the key pin (B) of the mounting bracket (C) to prevent the fan from rotating when in operation. Fig.10
Complete the electrical wiring according to the 'ELECTRICAL WIRING DIAGRAM' section below. (Fig.11)
⚫
Noted: The Abyss fan is a DC technology fan and cannot be used with an AC wall switch. If use AC wall
switch, on/off toggle wall switch – only, always leave in the "on" position and use remote.
6 | P a g e
Fig. 9
Fig. 10
Publicidad
