Taurus ATLANTIDA 3000 Folleto De Instrucciones página 7

Downloaded by: pd-oliana on 11-08-2022 08:50 CEST
SPRAY:
- The spray can be used in both steam and dry
ironing.
- Press the spray button ( A ) to use this opera-
tion.
- The spray button has to be pressed repeatedly
to release the first spray.
STEAM BLAST:
- This function provides extra steam for remov-
ing creases.
- Press the steam blast button ( B ). Wait a few
seconds until the steam penetrates the fibres of
the garment before pushing the button again.
For optimum steam quality, do not apply more
than three successive blasts.
- The spray button has to be pressed repeatedly
to release the first spray.
VERTICAL IRONING:
- It is possible to iron hanging curtains, items
of clothing on their own hanger, etc. To do so,
follow these instructions:
- Select the iron's maximum temperature by turn-
ing the iron's temperature regulator clockwise.
(Fig 2)
- Iron from top to bottom while pressing the
steam control ( B ). Important: for cotton and
linen, it is recommended to put the base of the
iron in contact with the material. For other more
delicate fabrics, it is recommended to keep the
base of the iron a few centimetres away.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance from the mains.
- Remove the water from the water tank.
- Clean the appliance.
CLEANING
- Unplug the appliance from the mains and let it
cool down before performing any cleaning task.
- Clean the appliance using a damp cloth with a
few drops of detergent and then dry it.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not immerse the appliance in water or any
other liquid, or place it under a running tap.
SELF-CLEANING FUNCTION:
- It is important to self-clean the appliance at
least once a month to remove calcium and any
other built-up minerals inside the iron.
- Fill the water tank to its maximum level, as
indicated in the "filling with water" section.
- Place the iron in an upright position, plug in to
the mains and select maximum temperature.
- Leave the appliance to heat up until the pilot
light indicates that it has reached its consigned
temperature.
- Unplug the appliance and place it in the sink.
- Press and hold the self-clean button.
- Let the water flow out through the steam vents
in the base, while lightly shaking the appliance.
- Release the button after a minute or when the
tank becomes empty.
- Leave the iron in the upright position until it has
cooled.
* HOW TO DEAL WITH LIME SCALE
INCRUSTATIONS:
- For the appliance to work correctly it should be
kept free of lime scale or magnesium incrusta-
tions caused by the use of hard water.
- To prevent this kind of problem, we recommend
the use of water with low lime or magnesium
mineralisation.
- Homemade solutions are not recommended
for de-scaling this appliance, such as the use
of vinegar.