Publicidad
Idiomas disponibles
Idiomas disponibles
Battery
Section 4
Your Battery's First Charge Is Important!
To assure the freshness of your battery and to avoid any operational problems
in shipping, it has been packaged in an UNCHARGED state.
For optimum operation of your flashlight, it should be charged a full
6 hours ... before using for the first time.
Battery Installation
If the battery was shipped outside of the flashlight: After you have removed the
flashlight from the Charging Cradle unscrew the tail cap (Fig. 8) and insert battery pack
(Fig. 9) into the barrel. The positive (+) end—this is the end with a button—goes into the
barrel first. Now screw on the tail cap and make sure it's tight.
NOTE: Large end of the battery spring must be snapped into the tailcap.
Fig. 8
Flashlight Barrel
8
–
+
Fig. 9
Battery Spring
Tailcap
First Charge Procedure
1. Connect charging cradle to the AC converter or DC accessory cord
(Fig. 10).
2. Plug into wall receptacle (AC) or DC power source cord.
3. Make sure charging cradle indicator LED is GREEN (see next page for
explanation of LED indicator colors).
4. Make sure flashlight tailcap is tight.
5. Place flashlight into charging cradle.
m
WARNING: As is the case with any battery, never allow it to short circuit and
do not expose the battery of this device to fire or excessive heat, as this could
cause the battery to leak, rupture or explode.
n
NOTICE: For prolonged storage, remove the battery pack and store it
separately in a non-conductive wrapping, such as a plastic bag. Cover the
metal terminals with insulating tape before disposal, to prevent accidental
short-circuiting.
Fig. 10
Publicidad
