Roadstar HRA-1500/N Manual De Instrucciones página 4

1 English
LOCATION OF CONTROLS
1A POWER ON/OFF
1. VOLUME KNOB
2. AM BAND SELECTOR
3. FM BAND SELECTOR
4. DIAL SCALE LIGHT
5. DIAL SCALE
6. TUNING KNOB
7. AC CORD
8. BATTERY COMPARTMENT
9. ANTENNA
POWER SOURCES
AC POWER: You can power your portable stereo system by plugging the AC power
cord (7) into a wall power outlet. Check that the rated voltage of your appliance mat-
ches your local voltage.
BATTERY POWER: To use the radio with batteries, disconnect the AC power cord
and insert 6 × "LR6" batteries into the compartment (8). Be sure that the batteries are
inserted correctly to avoid damage to the appliance. Remove the batteries when the
radio will not be used for a long period of time, as this will cause leakage to the batter-
ies and subsequently damage to your radio.
TO USE THE RADIO
1. Press [POWER] (1A) on right of product to power on or off the product.
2. Choose the radio wave band using the [AM/FM Band] button (2/3);
3. Adjust radio frequency to your desired station by turning the [Tuning Knob] (6);
4. Adjust the volume with the [Volume knob] (1);
Note: For a better reception of FM radio, reorient the antenna
Note: Press the [Light] button (4) to switch ON the Dial Scale illumination.
TECNICAL SPECIFICATIONS
Power
Power Input:
Radio Frequency Coverage
FM:
AM:
Speaker
Output Power:
Specifications and design are subject to possible modifications without notice due to
improvement.
AC 230V ~ 50Hz.
DC 9V = (6 x "LR6" Batteries).
88 - 108 MHz.
530 - 1600 KHz.
1 x 1.5 Wrms.
(9).