brennenstuhl DT Instrucciones De Uso página 19

DT / DT IP 44
Current time setting
1. Hold on OK button for over at least 5 seconds
under Clock mode, the WEEK DAY is flashing.
you can set the current time now.
2. Press UP or DOWN button to choose the desired
setting.
3. Press OK button to confirm it and the HOUR is
flashing.
4. Repeat step 2-3 until all the data have been set.
5. To reset the time, just repeat the above steps.
6. Press and hold M (DOWN) key for over 3 seconds
to turn the time display between 12 and 24 hour
mode during clock display status.
Program setting
With this timer, you can set up to 20 ON/OFF
programs. To do this, carry out the steps as
described in the example below.
Please note that if you don't press any button for
10 seconds, the timer will automatically return to
the clock display mode.
Alternatively you may press the MODE button.
Example for setting program 1:
MO 7:35 ON / MO 16:25 OFF.
In the above example, the clock switches on at
7:35 and off at 16:25 on Monday.
1. Press the MODE key until PROG 1 ON displays
and flashes. The program 1 ON mode is shown in
Fig. 1 without any setting.
Instructions manual
19