CASO DESIGN C1800M Manual Del Usuario página 46

 Ensure that the power cable does not hang down over a table or counter edge.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
13.5.1 Installation of the appliance
and on the sides at least 10 cm distance to other walls or units are needed.
c) The left side of the device must be open.
d) Do not remove the feet from the bottom of the appliance.
e) Do not cover or obstruct any openings in the appliance.
f) Covering the ventilation slots may cause damage to the appliance.
g) Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
2) Insert the power plug into a normal household outlet; check that voltage and
frequency of the appliance (see appliance rating label) matches that of the
household electrical supply.
13.5.2 Avoiding radio interference
The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
 Clean the door and the sealing surfaces of the device.
 Set the radio, the television, etc as far as possible away from the device.
 Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
 Use a properly installed antenna for the receiver, to ensure good reception.
1) Select a level surface providing
enough distance between the
ventilation slots and walls or
other units.
a) The surface for placing the
appliance must be at least 85 cm
above the floor.
b) The rear of the appliance must
be facing a wall (10 cm
distance). Above the appliance a
clearance of 30 cm is needed,
46