CASO DESIGN SV 400 Manual Del Usuario página 37

17.3 Rating plate
The rating plate with the connection and performance data can be founded on the back
side.
18 Operation
This chapter provides instructions on the proper operation of your device:
18.1 SousVide cooking
1. Plug in the power plug. The device is in standby mode.
2. Press any button to end standby mode and turn on the display, the device beeps.
3. Press and default setting of 60°C and 04:00 hours is displayed. Set desired
temperature with
4. Press again and set desired time with
5. Confirm with
6. The device will beep and time is flashing once temperature of the water is reached.
Place the vacuumed food into the cooking vessel. If needed weight the vacuumed
bags.
7. Start the timer with
8. The device counts down the time and will beep again, once time is over.
9. When you want to change the settings please press
described above.
10. You can deactivate the device by pressing
switch to standby mode.
► Risk of scalding! Carefully remove the food.
► If the device should indicate "E1" in the LED display after switching on even though
the water filled in is above the minimum level, please add some salt to the water and
stir well.
18.2 Disassembly / assembly of the stainless steel skirt
You can remove the stainless steel skirt for easier cleaning of the device by turning it
slightly counterclockwise and then pulling it down.
To assemble, put the stainless steel skirt back on and turn it clockwise.
.
and the device starts the heating process
.
Warning
Note: E1
.
and change settings as
for 3 seconds. The device will
37