Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature
controls
Door
alarm
WiFi
Connect
10
Preset Settings:
Allow 24 hours to reach these preset temperatures.
To turn off the cooling system in both the
either (+) pad until both displays show OFF.
To turn the cooling system on, press either
(-) pad. The preset temperatures of 0°F and
37°F will appear in the display.
NOTE: Frequent door openings or door left
open for periods of time may increase the
food compartments temporarily.
The actual temperature will vary from the set
temperature based on factors such as door
opening, amount of food, defrost cycling and
room temperature.
To turn the Door Alarm feature on, press
DOOR ALARM once. The ACTIVE light will
come on. To turn it off, press it again.
On models with a dispenser, the Door Alarm
feature is located on the dispenser panel on
Push this button to activate Monogram
Connect. See page 20 for more information or
go to monogram.com/connect to download
the App.
Controls
Non-Dispenser Models
Dispenser Models
To change the temperature settings, press
the (+) or (-) pads to desired temperature set
Allow 24 hours for the refrigerator to reach the
temperature you have set.
NOTE: Setting the controls to OFF stops
cooling, but does not shut off electrical power
to the refrigerator.
When the DOOR ALARM is active, the alarm
will flash and beep if you keep the door open
for more than 2 minutes.
Built-In Refrigerators
Temperature Ranges
Low
High
34°F
42°F
Fresh
Food
1°C
5°C
-6°F
4°F
Freezer
-21°C
-15°C
49-60815 Rev. 1
Publicidad
