Publicidad
3.
Install the Trim
Front Plate Assembly
Ensemble de plaque avant
Montaje de la placa frontal
Screws/Vis/Tornillos
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve stem with the correct length screw, as
selected in the "Install the Valve Stem Adapter" section of this guide.
Align the holes on the front plate assembly and the valve.
NOTE: Be sure to select the correct length screw for your application.
Attach the two screws through the front plate assembly and into the valve. Do not
overtighten.
Visually inspect the front seal plate assembly to ensure that the foam seal is
completely covering the wall opening. If not, stop the installation and repair the
wall opening.
Place the escutcheon against the wall. The drain holes in the escutcheon should be
positioned downward.
Thread the handle assembly onto the hub of the front plate assembly to secure the
escutcheon in place. The handle will be in the closed, vertical 6 o'clock position.
NOTE: If the handle does not engage the valve or the escutcheon does not tighten to
the wall, replace the valve stem adapter with an adapter of appropriate length.
Installer la garniture
Presser fermement les adaptateurs de tige de valve sur cette dernière.
Sécuriser l'adaptateur de la tige de valve à cette dernière avec une vis de longueur
correcte, telle que sélectionnée dans la section " Installer l'adaptateur de tige de
valve " de ce guide.
Aligner les orifices de la plaque avant et de la valve.
REMARQUE: S'assurer de sélectionner la vis de longueur correcte pour l'application.
Attacher les deux vis à travers l'ensemble de plaque avant et dans la valve. Ne
pas trop serrer.
1152821-2-A
Valve Stem Adapter
Adaptateur de tige de valve
Adaptador de la espiga de la válvula
Screw/Vis/Tornillo
Escutcheon
Applique
Chapetón
6
Handle Assembly
Ensemble de poignée
Montaje de la manija
Kohler Co.
Publicidad
