Publicidad
Idiomas disponibles
Idiomas disponibles
Parts identification
a
b
ER-GC70
A Main body
1 Dial
a. Scale marks
b. Instruction marks
2 Charge indicator lamp
3 Power switch [0/1]
B Blade block
4 Cleaning lever
5 Moving blade
6 Stationary blade
7 Mounting hook
(RE9‑49)(RE9‑5 for
United
ER-GC50
Kingdom)
C Comb attachment [A]
(1 mm to 5 mm)
D Comb attachment [B]
(6 mm to 5 mm)
E Comb attachment [C]
(6 mm to 45 mm)
F AC adaptor (RE9‑49/RE9‑5)
8 Power cord
9 Appliance plug
G Oil
H Cleaning brush
I Travel pouch
Accessories
C Comb attachment [A] (1 mm to 5 mm)
D Comb attachment [B] (6 mm to 5 mm)
E Comb attachment [C] (6 mm to 45 mm)
I Travel pouch
Charging the clipper
If the clipper is losing speed, it can be fully charged in 8 hours.
A full charge supplies enough power for approximately 40 minutes
of use.
1. Slide the power switch on the main
body to the "0" position to turn off
the clipper.
2. Plug in the AC adaptor into a
household mains socket.
3. Insert the appliance plug into the
clipper.
The charge indicator lamp lights and
stays on until the AC adaptor is removed
from a household mains socket.
4. Disconnect the AC adaptor from a
household mains socket when
charging is completed.
When charging the clipper for the first time or when it has not been
in use for more than 6 months, please charge it for 16 hours (in
order to activate the rechargeable battery). If you charge the
clipper with the battery completely discharged, the charge
indicator lamp may not glow immediately. However, the lamp will
glow normally after charging for a few minutes.
ER‑GC70 ER‑GC50
‑
‑
2
1
3
3
Publicidad
