Beko HSM46740 Instrucciones Para El Uso página 10

EN
Excess deposit of ice on the frame and the
baskets should be removed regularly with the
plastic scraper provided. Do not use any
metal parts to remove the ice.
The presence of this ice build-up makes
impossible to close the door correctly.
If you do not use your appliance for a few
days, it is not advisable to switch it off. If you
do not use it for a longer period, please
proceed as follows :
- unplug the appliance;
- empty the freezer;
- defrost it and clean it;
- leave the door open to avoid the formation of
unpleasant smells.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
If your appliance has a lock, keep it locked
and store the key in a safe place, out of the
reach of children. If you are discarding an
appliance with lock, make sure that, is made
ineffective. This is very important so as to
avoid children being trapped inside, which
may cause their loss of life.
Setting up
Your product was designed to operate at
an ambient temperature between -5°C and
+43°C. If the ambient temperature is above
+43 C, inside the appliance the temperature
0
can increase.
Set up the appliance far from any source of
heat and fire. Placing it in a warm room, the
direct exposure to sunbeams or near a heat
source (heaters, cookers, ovens), will
increase the energy consumption and shorten
the product life.
Please observe the following minimun
distances:
100 cm from the cookers working with
coal or oil;
150 cm from the electric and gas
cookers.
Ensure the free circulation of the air around
the appliance, by observing the distances
shown in Item 2.
Place the appliance in a perfectly even, dry
and well ventilated place.
Assemble the supplied accessories.
Electric connection
Your appliance is intended to operate at a
single-phase voltage of 220-240V/50 Hz.
Before plugging in the appliance, please make
sure that the parameters of the mains in your
house (voltage, currect type, frequency)
comply to the operation parameters of the
appliance.
The information concerning the supply
voltage and the absorbed power is given on
the marking label placed in the back side of
the freezer.
The electric installation must comply with
the law requirements.
The earthing of the appliance is
compulsory. The manufacturer has no
responsibility for any damage to persons,
animals or goods which may arise from the
failure to observe the specified conditions.
The appliance is endowed with a supply
cord and a plug (European type, marked
10/16A) with double earthing contact for
safety. If the socket is not the same type with
the plug, please ask a specialised electrician
to change it.
Do not use extension pieces or multiple
adapters.
Hot Surface Warning!
Side walls of your product is equipped with
refrigerant pipes to improve the cooling
system. Refrigerant with high temperatures
may flow through these areas, resulting in hot
surfaces on the side walls. This is normal and
does not need any servicing. Please pay
attention while touching these areas.
Switching off
The switching off must be possible by taking
the plug out of the socket or by means of a
mains two-poles switch placed before the
socket.
Operation
Before putting into operation, clean the inside
of the appliance (see chapter „Cleaning").
10
Instruction for use