Publicidad
Idiomas disponibles
Idiomas disponibles
On
Fig. 21
Fig. 22
Fig. 23
Fig. 24
Fig. 25
STORAGE
•
When your pressure washing session has been completed, turn off
the power switch located on the front of the power washer (Fig. 21).
Unplug the power cord from the outlet. Turn off the water supply. Pull
the trigger on the spray gun 2-3 times to drain out the excess water and
to release any remaining water pressure. Disconnect the garden hose
adapter from the water inlet. Do not allow the power washer to run with
no water flowing through it.
•
Remove high pressure hose from spray gun (Fig. 22) and unscrew the
other end of the high pressure hose from the power washer (Fig. 23).
•
Remove lance or detergent bottle from the gun and place in the
accessory holder (Fig. 24). Place the gun in the accessory holder on
the side of the power washer. Slide lances into the slots provided on
the back of the power washer. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle head with fresh
water to prevent clogging. Press the detergent bottle into the space
between the lance holders (Fig. 25)
•
DO NOT store the power washer where it is exposed to freezing
temperatures unless you use Pump Saver. It is recommended that
you use Pump Saver for storing in freezing temperatures. Freezing will
damage the pump unless Pump Saver is added to the power washer.
If not using or if storing your power washer for more than one month,
run Pump Saver through it. See the section on Pump Saver for more
information.
11
en
Publicidad
