Descargar Imprimir esta página

MaxxHome 20501 Manual De Usuario página 31

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
6.2. Manual reset/restart
If the heater is in lock-out mode, check and remove the cause of lock-out before
restarting the heater. To reset, turn the ON/OFF switch to 0 and then again to I. In case
of repeated malfunction, call technical service. Turning the thermostat control knob will
NOT reset the heater.
6.3. Shut-down
Move switch to "OFF" (O) position. Unplug the unit when not used for a long time.
▲ Never disconnect the heater from mains to stop it while in operation. Always allow
the cooling sequence to be completed (20503), otherwise the residual heat
could damage internal components.
▲ Do not cover the heater. Do not block the air inlet and outlet.
▲ The heater outlet is very hot during operation and after use. Do not touch! Use personal
protecting equipment if needed.
▲ Children should be supervised to ensure that they do not play with the appliance.
▲ The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
▲ Unplug the heater before moving it. Never pull the cable to unplug or move the unit.
▲ Do not leave the heater unattended when in use.
▲ Never use the appliance with wet hands or when either the heater or the power cable
is wet.
▲ If the supply cable is damaged, it must be replaced by the manufacturer, by a service
agent or a similar qualified person.
7. CLEANING, MAINTENANCE AND STORAGE
Regularly wipe the enclosure using a soft sponge or cloth. For very dirty parts, use a sponge wet-
ted with lukewarm water and a mild detergent, then dry using a clean cloth.
Keep air inlet and fan free from dust and dirt. To clean inner parts, gently blow compressed air
through air inlet.
Regularly inspect the power cable: if worn, cracked or damaged have it replaced by technical
service.
Before storing the heater, make sure it is perfectly cool and dry. Cover the unit with a plastic
bag, put it in its packing box and store it in a dry, ventilated place.
▲ Before starting any maintenance task, shut down, unplug and let the heater cool down for at
least 15 minutes.
▲ Do not attempt any electrical repair yourself. If the heater needs service or repair, contact a
qualified technician.
▲ Do not use a faulty unit unless a qualified technician has inspected and repaired it.
▲ When cleaning, make sure that water does not enter the unit.
▲ Do not open the enclosure to clean the inner parts. Do not spray water into the heater.
▲ Never use solvents, gasoline, toluene and similar aggressive chemicals to clean the heater.
The following checks BY QUALIFIED PERSONNEL ONLY are recommended before every seasonal
use:
Nozzle
Carefully unscrew nozzle from nozzle fitting. Blow compressed air through nozzle orifice to free it
from dirt. Replace nozzle if necessary.
31

Publicidad

loading

Este manual también es adecuado para:

2055320503