Publicidad
Idiomas disponibles
Idiomas disponibles
3. Device description (fig. 1-4)
1.
Load chain
2.
Hand chain
3.
Fastening hook
4.
Load hook
5.
Chain pulley
6.
Drive wheel
7.
Latch lock
4. Scope of delivery
• Chain hoist
• Manual
5. Intended use
The Chain Hoist is a device for vertical lifting and lowering of loads.
The chain hoist is provided for attachments (Attachment point - bottom) at altitudes from 3.0 to 3.5
meters. Outside this height, the hand chain must be shortened / extended accordingly.
The equipment is to be used only for its prescribed purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any
kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or industrial ap-
plications. Our warranty will be voided if the equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
6. Safety information
1.
The rated load limit must not be exceeded, as overload can damage the chain hoist or reduce
the lifting capacity in the future.
2.
Do not use electrical appliances to operate the chain hoist. The chain hoist is designed for
manual use only.
3.
Do not try to repair the load chain. If it is damaged, the load chain should only be replaced by
an expert. The load chain must be replaced with a new one of the same welded and hardened
steel, in the same size and strength/thickness.
4.
The load chain should be greased before use.
5.
The brake surfaces must not be greased. The brake must be kept dry
6.
Make sure that the load chain has no knots. If there are knots in the load chain, these must be
removed before use.
GB/MT
43
Publicidad
