General Safety Instruction For Power Tools - Aros PB-3603 Manual De Usuario

3
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
WARNING! READ ALL SAFETY DIRECTIONS AND INSTRUCTIONS.
Omissions in the compliance with safety directions and instructions can
cause Electrical shock and fire and/or severe injuries.
RETAIN ALL SAFETY DIRECTIONS AND INSTRUCTIONS FOR FUTURE USE.
The term "Power Tools" used in the safety instructions refers to mains-ope-
rated power tools (with power cord) and to battery-operated power tools
(without power cord).
1 WORK AREA SAFETY
1. Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
2. Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable li-
quids, gases or dust. Power tools create sparks,
which may ignite the dust or fumes.
3. Keep children and by standers away while ope-
rating a power tool. Distractions can cause you to
lose control.
2 ELECTRICAL
1. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools. Unmo-
dified plugs and matching outlets will reduce risk of
electrical shock.
2. Avoid body contact with earthed or grounded sur-
faces, such as pipes, radiators, ranges and refrige-
rators. There is an increased risk of electric shock if
your body is earthed or grounded.
3. Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase the
risk of electric shock.
4. Do not abuse the cord. Never use the cord for ca-
rrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the
risk of electric shock.
5. When operating a power tool out-doors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
6. If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.
3 NOTICE OF USING THE TOOLS
1. Don't over load the tool, select suitable tool to
work make you safe and high efficiency.
2. Don't use the tool if the switch can' work. Tool
should be repaired if switch not work.
3. Sure power disconnects the tool before adjusting,
repair, replace or storage the tool. It's avoiding in-
jury in use tool.
4. Storage the tool away the children, don't put tool
to non-training person operate.
5. Maintain tools. Always check tool, moving parts,
any damage parts are all can cause injury, always
maintain can avoid injury.
6. Keep blade sharp and clean. Sharp and clean bla-
de can easy be control and not jams
7. Read manual before use tool, Select suitable tool,
right accessory to be avoid injury.
4
UK