Cutting Artifice; Cleaning And Maintenance - Aros PB-3603 Manual De Usuario

12

CUTTING ARTIFICE

1. One hand operate tool, another should be away
the pruning shear working area 15cm, mustn't close
anybody.
2. Blade will be hurt or jammed if cutting bigger
branch forcedly.
3. Don't move the tool during the pruning shear cut-
ting; it will not keep you safety.
4. Use sleeve to fix the wire of device avoid wire
be draw by branch, that's will cause risk in working.
13

CLEANING AND MAINTENANCE

MAINTAIN
Repair mush sent to service. Use ori-
ginal part keeps the tool good condi-
tion and safe.
Switch batter power if you need
check the pruning shear.
Please wear glove before you check
the blade sharp or not, that's avoid
blade hurt you. Always check the
pruning shear termly, keep tool safe
and running reliable
CLEANING
Don't flush the tools or put it in water, it will cause
short circuit or damage the device.
Keep ventilation, motor and handle cleaning, always
use feather clean the device. Don't use cleanser
flush device, it will rust parts.
Cleaning the blade after every use, protect by oil or
spray protection.
Open the front cover of the pruner for keep on wor-
king 8 hours for cleaning the impurity (follwing the
maintenance picture).
5. Don't use the device in rain or humidity environ-
ment.
6. Should storage the device after use, take off wire
from battery and pruning, shut up power switch be-
fore storage.
Caution: please check battery capa-
city or blade sharp or not when cut-
ting difficult or not smooth.
SHARP
This maintains is very important to keep blade good
condition and life.
The tool have attach accessory to sharp blade,
always check blade at early, sure blade have good
condition to work.
ADJUSTING CLEARANCE OF BLADE
Always check and adjusting the clearance of blade
to 0.1mm will let cutting work turn too easy. Open
holder by screw; clockwise rotate screw, set clea-
rance to 0.1mm.
11
UK