Special Safety Instruction - Aros PB-3603 Manual De Usuario

3. GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
4 NOTICE USING CORDLESS TOOL
1. Sure switch off position at insert battery. Insert
battery and connect tool at switch on position will
cause damage.
2. The tool design only use original charger. Use
other charger charging battery cause damage.
3. The tool design only use original battery. Use
other battery match the tool cause damage.
4. Storage battery away metal parts, like clip, coin,
key, nail, screw or other small metal parts. Short cir-
4

SPECIAL SAFETY INSTRUCTION

1 PRUNING SHEAR SPECIAL SAFETY INS-
TRUCTION
a) Keep anybody away at least 15cm, don't move
cutting parts at blade working. Carefully operate the
equipment can avoid injury.
b) Move the tool at blade not moving. Protection
guard is must at storage the tool. Protect blade to
reduce damage.
2 OTHER SAFETY INSTRUCTION
Wear suitable work clothes such
as boots with non-slip soles,
sturdy long trousers, gloves and
goggles.
Do not wear long flowing clothing
or jewelry, as moving parts may
catch this.
Do not use this tool while walking
barefooted or while wearing open
sandals.
cuit battery will cause fire.
If liquid leakage out and touch you body, flush by
clean water. Must see a doctor if liquid touch eyes.
Liquid of battery will canker or burning.
5 REPAIR
Have your power tool serviced by a qualified repair-
person using only identical
Replacement parts. This will ensure that the safety
of the power tool is maintained.
i) Do not use the pruning shear in the rain.
j) The appliance is designed for trimming hedges
or branches. Do not use to cut twigs, hard wood or
other objects.
k) Do not attempt to dislodge a blocked/trapped bla-
de before switching the tool off.
l) Before commencing with the trimming check the
hedge or branch for hidden objects such as wire
etc.
m) When operating the appliance, always hold it
well with both hands and at some distance away
from your body.
n) Do not use the tool in the vicinity of flammable
liquids or gasses. Fire and
Explosion risk exists in the event of a short circuit.
o) The blades have to be checked for wear in regu-
lar intervals and reshape ended. Blunt blades will
overload the machine. Resulting damages are not
covered by warranty.
p) Do not attempt to repair the tool your-self, unless
you are schooled in this field. All works, which are
not described in this manual, may only be performed
by our Service-Centre
5
UK