Trouble Shooting - Aros PB-3603 Manual De Usuario

18

TROUBLE SHOOTING

PROBLEM
Equipment can not start
Run abnormal
Blade super heat
Cutting surface bad
Can't charging, red led flash
Two warning note appears and
the two warning note repeat 10
times
Three warning note appears and
the two warning note repeat 10
times
Four warning note appears and
the two warning note repeat 10
times
Ten warning note appears and
the two warning note repeat 10
times
REASON
Battery use up
Disconnect battery
Switch off
Switch fail
Connect not good
Switch fail
Blade dull
Blade damage
Lubricate not enough,
Friction force added
Dirt on blade
Blade dull
Artifice not enough
Battery empty
Battery not fully insert charger
Charger not connect power
Electrode dirt
Battery failure
Charger fail
The signal for cutting opening
positioning fail, shear is out of
work
The signal for cutting closing
positioning fail, shear is out of
work
Motor winding fail, shear is out
of work
Small maintenance
14
SOLVE
Charging battery
Connect battery
Switch on
Connect service repair
Connect service repair
Sharp blade or replace
Sharp blade or replace
Use grease on blade
Use grease on blade
Clean blade
Sharp blade or replace
Read instruction carefully
Charging battery
Re-insert the battery to charger
Re-connect
Clean dirt
Replace battery
Replace charger
Send shear to service center for
repairing
Send shear to service center for
repairing
Send shear to service center for
repairing
To add oil for screw pin
UK