Working Environment - Aros PB-3603 Manual De Usuario

11

WORKING ENVIRONMENT

1. Keep environment temperature at 0°C y 45°C
when charging battery, keep -10°C y +60°C when
battery work.
2. Keep tool in -5 ºC y 30 ºC temperature when work.
OPERATION
Please wear suitable cloth and
glove when operate this tool. Al-
ways check tools before use, sure
on/off switch and safe switch are
all ok. The power should be put
off when you loosen the trigger.
Must stop use tool if switch fail-
ure. Always check rated voltage
of battery match pruning shear.
Use safety guard device can re-
duce risk in work.
Check frequency of blade work,
Keep good work condition any-
time
Switch off the machine, blade
will stop in many second, must
sure blade stop fully before touch
it, otherwise blade will hurt your
body.
1. For the output direction of the cable and the direc-
tion of holding the pruner,
2. Please keep they are the same. It is decided by
you habit, you can connect to right side if you are
right hand or left side if you are left hand.
3. Adjusting your backpack and fasten your belt.
4. Connect the cable with pruner tightly
5. Turn on the power switch. After warning tone,
please pull the trigger two times without holding.
And the shear will be on working condition after one
more warning tone. If the shear keeps unmovable
during working, please check whether the screw
of wire connecting the shear and battery is tightly
enough. If the screw loose, please tight it and open
the power again. If shear keeps unmovable after
long time working, and it comes four continuous
warning notes, it means the electricity is running
out. Please charge the battery immediately.
6. Don't overload cutting, it will protect pruning
shear and battery not be damaged. Don't cutting
over 28mm living plant or 20mm dry branch.
7. User just loose trigger when the blade has been
jammed by branch, the blade will resume maximum
position. Caution: Don't sway the pruner from the
left to right in order not to damage the edge of blade
during the resume process of blade.
8. Changing the open size of blade: We can adjust
the open size of blade from big open size to small
open size by pressing the black button on the shear.
Please identify the length of warning note when
press the black button on the shear. If warning note
is long, it means the cutting size is big, if it is short,
it means the cutting size is small. Please see as
below: When the open size of blade maintain max-
imum position, Please press the trigger and main-
tain 5 seconds unchanged Then the blade will keep
closed state forever. When you loose the trigger and
press the trigger 2 times continuously, the open size
of blade will be changed into small open size. If you
want to change the small open size into big size, the
method is the same. You can adjust them again and
again.
9. When you stop working, please press the trigger
and maintain 5 seconds unchanged then the blade
will keep closed state. Then turn off the power
switch and pull out the cable from the battery.
10
UK