Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
TUBING AND FLOW RESTRICTOR INSTALLATION
INSTALLING THE TUBING TO TANK
AND FAUCET
.
Measure
3/4" from
the end of each
remaining
piece
of tubing
(faucet
end and
inlet end) and mark with
a pencil.
(Check
for roundness,
smoothness,
cuts,
nicks,
flat spots
and sharp
edges).
3/4"
19 mm
INCORRECT
.
.
Push the tubing
firmly
into
each fitting
on
the manifold
until
the line is flush
with
the
fitting
collar.
(If the tubing
is removed,
re-
cut the end,
measure,
mark
and re-insert).
Tubing
must
be fully
inserted
to avoid
leaks. To remove
tubing:
depress
and hold
red or blue collet; pull tubing out to remove.
Red or Blue Collet
F_
(DO NOT REMOVE) --__
i
Insertion line _
3/4"._
i
i
Insert tubing
----_
_l_'?-
ngagement-_
3/4"
--
/8" tubing)
/ /
//
/
Pul out slightly
on tubing
to ensure
a
good
seal.
FLOW RESTRICTOR
REPLACEMENT
PROCEDURE
Each time
the Reverse
Osmosis
cartridge
is
changed,
you will
need to replace
the flow
restrictor
in the drain
line as well.
Be sure to wash
your
hands
before
handling
inner
parts of the system.
FLOW RESTRICTOR
REPLACEMENT
PROCEDURE (cont.)
.
Remove
drain
line tubing
by pushing
up
on the drain
line collet
with
one hand
(1)
and removing
the drain
line with
the
other
hand
(2).
.
Once the drain
line has been removed
from
the system
base, grasp
the end of
the flow
restrictor
and pull it straight
out
from
the tube*.
If the restrictor
is difficult
to remove
by hand,
a pair of pliers
may
be used to grip the end of the restrictor
to aid in removal
from
the tubing.
*In some instances,
the restrictor
may slide out of the
drain tubing
as it is removed
from the drain line port.
If, after removing
the drain line as described
in step 1,
the restrictor
is no longer in the end of the tubing,
check the drain line port. Remove the restrictor
from
the port and proceed to step 3.
3.
Take new restrictor
and slide it back into the
drain tubing.
Insert the restrictor
by hand
only. Do not use pliers to insert.
Make sure
to insert restrictor
all the way into the
tubing.
Failure
to do so could
result in
improper
operation
of the RO system.
.
Reinsert
drain
line tubing
in system
base.
Tug lightly
on the tubing
to ensure
that
the collet
is engaged
and has a proper
grip on the tubing.
12
Publicidad
