Publicidad
Idiomas disponibles
Idiomas disponibles
1
!2
w
II
2
1
2
3
The clock is displayed. (The '(:" between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet
for the first time after purchase or when the clock setting is
canceled due to a power failure, the entire clock display
flashes.
Press CLOCK.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
++
or *
is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Press ENTER or Il.
The clock starts from 00 seconds.
To
restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock
when another display
is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original
display reappears.
However, the clock cannot be
displayed durin,g recording.
To
switch to the 24-hour standard
Press the CLOCK and then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
~
This is caused by a power interruption. The current time needs
If power is interrupted for more than approximately 24 hours,
all settinas stored in memory after purchase need to be reset.
—1
The unit can be turned off automatically at a specified time.
Use
the
remote control.
1 Press SLEEP.
2 Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
44
and -
are also available instead of MULTI JOG.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To
cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF appears on the display.
If the power-economizing
mode (page 8) is on, all the display
lights turn off when the power
is turned
off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.
30
ENGLISH
Publicidad
