Publicidad
Idiomas disponibles
Idiomas disponibles
The operation ofanytractor c anresult i nforeign o bjects t hrown i nto the
eyes, which canresult i nsevere e yedamage. Always w ear s afety g lasses
oreyeshields while operating your t ractor o rperforming anyadjustments
orrepairs. Werecommend
standard safety g lasses ora wide vision safety
mask worn over s pectacles.
HOW TOUSEYOUR TRACTOR
TO
SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing
switch. When engine is
running, any attempt bythe operator to leave
the seat without first setting the parking brake
will shut off the engine.
1. Depress clutch/brake
pedal (B) all the
way down and hold.
2. Pull parking brake lever (C) up and hold,
release pressure from brake pedal (B),
then release parking brake lever. Pedal
should remain in brake position. Make
sure parking brake will hold tractor secure.
STOPPING
MOWER BLADES -
To stop mower blades, move attachment
clutch clutch lever to "DISENGAGED"
position (1"_).
NOTE: Failureto movethrottle controt between
half and full speed (fast) position, before
stopping,
may cause engine to "backfire".
* Turn ignition key (F) to "STOP" position
and remove key. Always remove keywhen
leaving tractor to prevent unauthorized use.
. Never use choke (N) to stop engine.
iMPORTANT:
Leaving the ignition switch in
any position other than "STOP" will cause
the battery to discharge and go dead.
NOTE: Under certain conditions when tractor
is standing idle with the engine running, hot
engine exhaust gases may cause "brown-
ing" of grass. To eliminate this possibility,
always stop engine when stopping tractor
on grass areas.
_ICAUTION:
Always stop tractor com-
pletely, as described above, and set parking
brake before leaving the operator's position.
TO USE THROTTLE
CONTROL (D)
Always operate engine at full speed (fast).
. Operating engine at less than full speed
(fast) reduces
engine's
operating
effi-
ciency.
. Full speed (fast) offers the best mower
performance.
(1_1) Attachment
(r_)Attachment
Clutch Switch
Clutch Switch
"Engaged ....
Disengaged"
GROUND DRIVE -
To stop ground drive, depress clutch/brake
pedal all the way down.
Move gear shift
lever
(J) to neutral
position.
ENGINE -
Move throttle control (D) between half and
full speed (fast) position.
TO USE CHOKE CONTROL (N)
Use choke control whenever you are starting
a cold engine. Do not use to start a warm
engine.
To engage choke control, pull knob out.
Slowly push knob in to disengage.
15
Publicidad
