ims PRO TIG PRO 200 DC Manual Del Usuario página 16

Translation of the original instructions
USE WITH EXTENSION CABLES
All extension cables must have an adequate size and section, relative to the machine's voltage .
Use an extension that complies with national safety regulations.
SYMBOLS & MENUS
FUNCTION
HF ignition
Lift ignition
Pre-gas
Up slope current
Welding current
Courant froid
PULSE Frequency
Down slope current
Post gas
HotStart
ArcForce
TIG PULSE
TIG SPOT
MMA PULSE
2T
4T
4T LOG
Ampere (unit)
Volt (unit)
Second or Hertz (units)
Percentage (unit)
Display switch A or V
Program menu access
Thermal protection
Sleep mode
16
Input voltage
TIG PRO 200 DC
TIG
PICTOGRAM
DC
X
X
X
X
X
X
X
10
s
X
20
s
0
s
X
X
X
X
X
X
X
A
X
V
S / Hz X
X
%
A
X
V
MEM
X
PROG
X
X
TIG PRO 200 DC
Length - Extension selection
230V
MMA Comment
TIG process with HF ignition
TIG process with LIFT ignition
Time to purge the torch and to protect the area with gas before ignition
Up slope current
Welding current
Second welding current or «cold» current in standard 4TLOG or in PULSE
mode
X PULSATION frequency of the PULSE mode (Hz)
Down slope current to minimum current, I Stop (S) to prevent weld defects
and craters.
Length of time in which gas is released after the arc has stopped. It protects
the weld pool and the electrode against oxidization when the metal is cooling
(S).
X Adjustable overcurrent at the beginning of the welding (%)
Overcurrent delivered to avoid sticking when the electrode enters the welding
X
pool
Pulse mode
Spot mode
X MMA process in PULSE mode
2 time torch mode
4 time torch mode
4 time LOG torch mode
X Amperes unit for welding current settings
X Volt unit for displaying welding voltage
X Seconds or Hertz unit for time or frequency settings
X Percentages unit for proportionate settings
X Switches the display of voltage or current during and after welding
X Access to configuration menu (SAVE, JOB, ...)
X Standard symbol to indicate the thermal protection state
X Sleep mode
< 100m
2.5 mm²
EN