Publicidad
Idiomas disponibles
Idiomas disponibles
B Connecting to a power source
You can use the following power sources:
• AC power adaptor (see "Playing an audio
CD or ATRAC3plus/ATRAC3/MP3 files")
• LR6 (size AA) alkaline batteries
For the battery life, see "Specifications."
Using the dry batteries
Use only the following dry battery type for
your CD player:
• LR6 (size AA) alkaline batteries
Note
Be sure to remove the AC power adaptor when
using the dry batteries.
1
Open the battery compartment lid
inside your CD player.
2
Insert two LR6 (size AA) batteries
by matching the 3 to the diagram
in the battery compartment and
close the lid until it clicks into
place.
24
-GB
Insert # end first
(for both batteries).
To remove the batteries
Remove the batteries as illustrated below.
When to replace the batteries
You can check the remaining power of the
batteries in the display.
Replace the batteries when "
t
t
Lo batt*
* Beep sounds.
When the batteries are depleted, replace both
batteries with new ones.
Notes
• The indicator sections of
remaining battery power. One section does not
always indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
sections of
may increase or decrease.
To attach the battery compartment lid
If the battery compartment lid is detached by
an accidental drop, excessive force, etc.,
attach it as illustrated below.
" flashes.
t
t
t
roughly shows the
Publicidad
