Domair TX-601D Instrucciones De Uso página 25

Assembly, use and operation
1. MOUNTING
1) Front grille
2) Rear grille
3) Base
4) Clamp
5) Rotary switch
6) Cleat screw
7) Handle
8) Central appliance body
9) Small metal screw
Remove the cleat screw and the small
metal screw from the fan head.
Insert the fan head into the central
body, replace the cleat screw in its
housing, then screw the small metal
screw.
2. OPERATION
To operate the fan, connect the cord to
a 230V electrical outlet and use the
switch on the back of the motor
housing.
Turn the switch to the "1" position for
low speed operation.
Maintenance
• The appliance must be cleaned
and checked regularly. No disassembly
is necessary.
• BEFORE
ALWAYS UNPLUG
CORD!
Rev 0_27 08 19 Fabriqué en Chine
SERVICING,
THE POWER
Switch the switch to "2": the fan runs at
the highest speed.
To turn off the fan, set the switch to the
"O" position.
3. USE
To tilt the fan head, loosen the cleat
screw and tilt the fan head to the
desired position. Then tighten the screw
firmly to keep the desired position.
The fan has the ability to rotate 360
degrees by manually rotating the fan
head.
Install the fan on the provided stand for
use as a table fan, or use the clamp to
clip it to a suitable stand.
• Take care that water or other
liquids do not come in contact with the
motor or any other electrical parts
during cleaning.
• Use a soft, slightly damp cloth
to clean your fan, and then dry it.
Page 25