GE Quick Set V Manual Del Propietário página 38

Before Vou Call For Service...
Troubleshooting Tips
Possible Causes What To Do
Clock and timer do Plug on range is not completelg . Hake sure electrical plug is plugged into a live, properlg
not work inserted in theelectrical outlet, grounded outlet.
A fuse in gour home • Replacethe fuse or reset the circuit breaker.
mog be blown or the
circuit breaker tripped.
Oven controls improperlg set. . See the Using the kitchen timer section.
Oven will not self-clean The oven temperature is • Allow the range to cool and reset the controls.
too high to set o self-clean
operation.
Oven controls improperlg set. • See the Using the self-cleaning oven section.
The probe is plugged into . Remove the probe from the oven.
the outlet in the oven.
(on some models}
"Crackling" or This is the sound of the . This is normal.
"popping" sound metal heating and cooling
during both the cooking end
cleaning functions.
Excessive smoking Excessive soil. , Touch the CLEAR/OFFpad. Open the windows to
during a clean cycle rid the room of smoke. Wait until LOCKED/DOOR
goes off. After the oven cools, wipe up the
excess soil and reset the clean cgcle.
Oven door will not Oven too hot. , Allow the oven to cool below locking temperature.
openafter a clean cycle
Oven not clean after a Oven controls not properlg set. • See the Using the self-cleaning oven or Using steam clean section.
clean cycle
Oven was heavilg soiled. , Clean up heavg spillovers before starting the clean
cgcle. Heavilg soiled ovens mag need to be cleaned again.
"LOCKED" flashes The self-clean cgcle has been , Close the oven door.
in the display selected but the door is not
closed.
"LOCKED"is on The oven door is locked , Touch the CLEAR/OFFpad. Allow the oven to cool.
when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--" and a number
or letter flash
in the display
You hove a function error code.. Disconnect all power to the range for at least
30 seconds and then reconnect power. If the function
error code repeats, call for service.
38