Before You Call For Service...
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Possible Causes
What To Do
Surface units will not
Improper cookware
• Use pans which are flat and match the diameter of
maintain a rolling boil
being used.
the surface unit selected.
or cooking is not
In some areas, the power
. Cover pan with a lid until desired heat is obtained.
fast enough
(voltage) meg be low.
Surface units do
A fuse in gour home meg be
• Replacethe fuse or reset the circuit breaker.
not work properly
blown or the circuit breaker
tripped.
Cooktop controls
. Check to see the correct control is set for the surface
improperly set.
unit you are using.
Surface unit stops
This is normal. The unit
glowing when turned
is still on and hot.
to a lower setting
Scratches (may appear
Incorrect cleaning
, Scratches are not removable. Tiny scratches will become
as cracks) on cooktop
methods being used.
less visible in time as a result of cleaning.
glass surface
Cookware with rough bottoms
, To avoid scratches, use the recommended cleaning
being used or coarse particles
procedures. Make sure bottoms of cookware are clean
Isalt or sand) were between
before use, and use cookware with smooth bottoms.
the cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Areas of discoloration
Food spillovers not cleaned
• See the Cleaning the glass cooktop section.
on thecooktop
beforenextuse.
Hot surface on a model
. This is normal. The surface may appear discolored
with a light-colored
cooktop,
when it is hot. This is temporary and will disappear
as the glass cools.
Plastic melted to
Hot cooktop came into
, See the Glass surface-potential
for permanent damage
the surface
contact with plastic placed
section in the Cleaning the glass cooktop section.
on the hot cooktop.
Pitting (or indentationl
Hot sugar mixture spilled
. Call a qualified technician for replacement.
ofthecooktop
on the cooktop.
Frequent cycling
Improper cookware
. Use only flat cookware to minimize cycling.
offend
on of
being used.
surface
units
Oven light does
Light bulb is loose.
, Tighten or replace the bulb.
not work
Oven will not work
Plug on range is not completely . Hake sure electrical plug is plugged into a live, properly
inserted in the electrical outlet,
grounded outlet.
A fuse in your home may
• Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
Oven controls improperly set.
• See the Using the oven section.
Oven too hot.
. Allow the oven to cool to below locking temperature.
36